Onyx Giant Disc Bridge Saw Machine in Netherlands

The Helios Circular saw is for squaring blocks and slate production out of sand stone, lime stone, marble en granite. With this machine you are able to produce automatically without operator attention in this way it is possible to produce very efficient.
Blade diameter 600 1200 1600 2000 2500 2700 3000 3500mm
Saw depth 210 450 630 800 1025 1125 1200 1450mm
With stationary bridge and moveable saw car or
Moveable bridge over rails
Saw reach 1.2 x 2.0 m up to 5.5 x 7.0 m
Saw car 5000 x 2500 mm / 25 ton load possible
Suitable for fully automatic production

This machine is designed for sawing slabs in an automatic program. Slabs can be placed and the machine can cut all the strips in automatic program.

You can use the saw also overnight with unmanned operation because the safety features, the machine will stop automatic if:

Drive belt Breach
Amperage protection
Water failure
Trips out of a movement motor is in failure
Saw Table

Saw table rotating through roller bearing
Base welded and powder coated
Fixation points on 0-90-180-270 and a manual brake to fixate in every position.
Table rotates manual
Top surface equipt with wooden strips 3x1.5 m
Program - The following values can be set per block:
The starting point for the first cut
The place where the width of the block ends, means an adjustable stop
The offset for the blade thickness
The number of slabs and the thickness.
There are 5 different slab sizes that can be put in the program. The number of repeat is unlimited
Central lubrication
Automatic lubricating pump which lubricate the essential parts Castrol Olit CLS grease
Electrification Suited for 400 V – 50Hz, 3 phase with 0 And earth
The machine is wired completely and is equipped with a stationary control cabinet, PLC control, The motors applied are fully closed and at least comply with form of protectionIP55 and insulation class F

This machine is designed for sawing slabs in an automatic program. Slabs can be placed and the machine can cut all the strips in automatic program.

You can use the saw also overnight with unmanned operation because the safety features, the machine will stop automatic if:

Drive belt Breach
Amperage protection
Water failure
Trips out of a movement motor is in failure
Saw Table

Saw table rotating through roller bearing
Base welded and powder coated
Fixation points on 0-90-180-270 and a manual brake to fixate in every position.
Table rotates manual
Top surface equipt with wooden strips 3x1.5 m
Program - The following values can be set per block:
The starting point for the first cut
The place where the width of the block ends, means an adjustable stop
The offset for the blade thickness
The number of slabs and the thickness.
There are 5 different slab sizes that can be put in the program. The number of repeat is unlimited
Central lubrication
Automatic lubricating pump which lubricate the essential parts Castrol Olit CLS grease
Electrification Suited for 400 V – 50Hz, 3 phase with 0 And earth
The machine is wired completely and is equipped with a stationary control cabinet, PLC control, The motors applied are fully closed and at least comply with form of protectionIP55 and insulation class F